I always hated to cut my Amiga wedges cases to integrate things, for several reasons like when you want to sell it, you want it as vanilla as possible and also because I’m very bad at manual things.

Some months ago, I bought a Gotek from Relec.ch but never found a correct way to integrate it in my Amigas, so I left it behind for a while after having it flashed with XhC firmware (supporting read/write ADF !).

I just found out that a CrazyBob guy posted a special mount for Gotek A600 on Thingiverse. I ordered one through my local 3D priting service and tested it. It works perfectly !

Get this mount here